WISECOM, INC. WS-1414IM4 Card Type Modem (asynchronous) Chipset UMC Maximum Data Rate 14.4Kbps Maximum Fax Rate 14.4Kbps Data Bus 8-bit ISA Fax Class Class I & II Data Modulation Bell 212A ITU-T V.22, V.22bis, V.23, V.32, V.32bis Fax Modulation ITU-T V.17, V.21CH2, V.27ter, V.29 Error Correction/Compression MNP5, V.42, V.42bis [Image] CONNECTIONS Function Label Function Label Line in CN1 Line out CN2 SERIAL PORT ADDRESS SELECTION Setting SW1/1 SW1/2 3F8h (COM1:) On On 2F8h (COM2:) Off On 3E8h (COM3:) On Off 2E8h (COM4:) Off Off INTERRUPT SELECTION Setting SW1/3 SW1/4 SW1/5 SW1/6 IRQ2 On Off Off Off IRQ3 Off On Off Off IRQ4 Off Off On Off IRQ5 Off Off Off On SUPPORTED STANDARD COMMANDS Basic AT Commands +++, ‘comma’, A/ A, D, E, H, L, M, N, O, P, Q, T, V, X, Y, Z &C, &D, &F, &G, &K, &L, &P, &S, &T, &V, &W, &Y, &Z Extended AT Commands \A, \B, \C, \G, \J, \K, \N, \Q, \T, \X %A, %B, %C, %D, %E, %N, %Q S-Registers S0, S1, S2, S3, S4, S5, S6, S7, S8, S9, S10, S11, S12, S14, S16, S18, S21, S22, S23, S25, S26 S27, S30, S91 Note: See MHI documentation for complete information. UNIDENTIFIED COMMANDS Command Default S15 83 S17 75 S19 3 S20 0 S24 72 S28 16 Proprietary AT Command Set AUTO-RELIABLE FALLBACK CHARACTER Type: Register Format: AT [cmds] S29=n [cmds] Default: 0 Range: Unidentified Unit: 1 ASCII character Description: Sets the character used as the auto-reliable fallback character. COMMUNICATION PROTOCOLS Type: Configuration Format: AT [cmds] Bn [cmds] Description: Selects the communication protocol for low-speed data calls. Command Protocol B0 Modem will use ITU-T V.22 at 1200bps. B1 Modem will use Bell 212A at 1200bps. B2 Modem will use ITU-T V.23 at 1200bps. DISPLAY INFORMATION Type: Immediate Format: AT [cmds] In [cmds] Description: Displays information requested about the modem. Command Function I0 Displays product identification code. I1 Displays ROM checksum. I2 Tests and displays ROM checksum. I3 Displays firmware revision and model ID. I5 Displays country code. EXTENDED RESULT CODES Type: Configuration Format: AT [cmds] \Vn [cmds] Description: Selects error correction and compression extended result codes. Command Function \V0 Error correction and compression extended result codes disabled. \V1 \REL added to reliable mode connections. \V2 All error correction and compression extended result codes enabled. SLEEP TIMER Type: Register Format: AT [cmds] S13=n [cmds] Default: 6 Range: 0 - 255 Unit: 1 second Description: The function of this register is unidentified.